Blackhawk Upper Control Arms – Mitsubishi Triton MQ, MR, Pajero Sport QE

Blackhawk Upper Control Arms - Mitsubishi Triton MQ, MR, Pajero Sport QE

Newly released is the UCA4729Q for the current range Mitsubishi Triton MQ, MR, and the Pajero Sport. Upgrades include a fixed amount of increased caster with a small change to camber correction, improving the bulk of wheel alignment issues with increased clearance. This allows the factory lower control arms to be used to fine tune wheel alignments. Featuring increased clearance of the control arm to the suspension strut allowing for larger struts to be installed without the common clearance issues associated.

• Retains factory droop stop - with customisable height shims.
• 2 Stage coating with E-Coat and Gloss Black Powder Coat.
• Hi Articulation Roadsafe 4WD HD Ball Joint (OE Sized).
• 2 degrees increased caster.
• OE Sized Rubber Bushings
• ADR is Compliant for street use! *Engineering Required
• Retains all brake line and ABS line mounts.
• Driver's side adjustable headlight mount included.

The new heavy-duty Roadsafe "BLACKHAWK" range of Upper Control Arms have been designed with ease of fitment & ongoing serviceability in mind and are a necessity for various IFS models that have been lifted 30mm+. The Roadsafe "BLACKHAWK" arms have been designed to restore camber & caster lost on the IFS vehicles once they have been lifted, by correcting the angle of the ball joint. Without restored camber & caster settings lifted IFS vehicles will eventually show excessive tyre wear and experience ride & steering issues.

With greater radius and tube sizing to suit per application, the designs allow clearance of the coils during articulation, with the outer radius also adjusted to allow for the fitment (in some cases) of 35" tyres without having the issue of the tyres rubbing on the arms during the full lock. Manufactured in Heavy Duty 32mm OD (6mm wall thickness) STKM13A Carbon Steel Tube - for optimum strength without putting too much additional weight onboard.

We haven't gone with a complicated ball joint or bushing setup - we have designed the Ball Joint & bushing apertures to take OE spec componentry! That way if you have a ball joint or bushing issue in an out of the way area, where getting spares can be a drama, you can replace your affected part with a standard OE Spec factory or aftermarket unit.

Roadsafe "BLACKHAWK" Upper Arms are designed with 3 degrees fixed caster and optimally suited to lifts of 30-70mm, finished in dual layer coating including black e-coat and Gloss Black Powder Coat for maximum durability, rust prevention and discreet installation.

SKU: UCA4729Q