Enerdrive 12V DC2DC 40 Amp Battery Charger DC To DC MPPT Solar EN3DC40
$483.00 inc. GST
About this product
Enerdrive 12V DC2DC 40 Amp BATTERY CHARGER DC TO DC MPPT SOLAR EN3DC40
Enerdrive EN3DC40+ Multi-stage Charging Process. The ePOWER DC2DC+ Battery Charger is a fully automatic, set and forget charger. It is designed to quickly and accurately recharge your deep cycle batteries utilising charger algorithms that help to maximise the life of your specialised deep cycle batteries. The ePOWER DC2DC+ Battery Charger features multistage smart charging technology that enables the charger to be connected to your battery bank permanently. With the input of multiple sources, you can be assured of charging your batteries whenever underway; or when the sun is shining on your solar array. As dictated by battery manufacturer’s recommendations, deep cycle batteries require a multistage charge sequence for perfect, fast and accurate charging. The Enerdrive ePOWER DC2DC+ smart charger delivers three primary charge stages.
Stage 1 – Bulk or Boost charge; The battery is charged at full rated output current of the charger until the battery reaches its final charging voltage, known as its absorption voltage. In this step, around 80% of the battery is recovered as fast as possible.
Stage 2 – Absorption Charge; With the charger voltage held steady, the remaining 20% is replaced with the charger allowing the current to taper off as the battery approaches full charge.
Stage 3 – Float; Finally, in the float stage the charger voltage is lowered and held at a constant and safe predetermined level. This prevents the battery from being overcharged, yet allows the charger to supply enough current to make up for the self-discharge losses of the battery, while supporting any additional loads connected to the battery (such as DC lighting and refrigerators). This stage allows for the charger to be used as a DC power supply.
Smart Charging Feature
The ePOWER DC2DC+ Battery Charger will regulate its output based on the loads connected to your battery bank. This function is important to maintain the life of your battery bank as some battery chargers mistake loads for discharge and continue to keep the batteries in the bulk or absorption stage for extended periods of time, which will damage the battery bank. The ePOWER DC2DC+ Battery Charger has two methods of load based regulation to ensure your battery charger transitions to float when it should do so.
Product Type: 12v 40Amp DC2DC Battery Charger
Maximum Output: 50A
Charger Mode Output Voltage: 13.8V – 15.5V
Float: 13.0V – 13.8V
Charging Control: Three Stages
DC Output: Single
Selectable Battery Type: Gel, AGM, Flooded, Lithium, Program
Charger Efficiency: 95%
Temperature Setting: Low/ Normal/ High (Battery Temperature Sensor Standard)
Dimensions (LxWxH mm): 1.85Kg
NOTE: For all installation that requires additional wiring, we recommend you engage a licensed auto electrician.
|Dimensions||74 × 24 × 17 cm|